42
Chapter 4, Using the Command Center
Setting the device date and time
You can set the date and time manually or automatically by using an NTP server.
¡ Important To save changes made in the Date and Time tab, you must click
the
Apply button. A Monarch HDX hardware reboot is required to apply the
changes. If you leave the
Date and Time tab before clicking Apply, all changes
will be lost.
*Setting the date and time automatically requires a local or public NTP server address. An
Internet connection is required to use a public NTP server.
Manually Automatically*
1 Select Manual.
2 Set the Time, and enter a Date in
the format DD/MM/YYYY, or
click to select a date from the
calendar.
3 Click Apply. You’ll be notified
that Monarch HDX will be
rebooted in order to apply the
changes.
1 Select Automatic.
2 Enter a local or public NTP server
address. The default NTP server
address is time.nrc.ca.
3 Select a Time zone from the list.
The current date and time
associated with the selected NTP
server and time zone are displayed
next to
Current date and time.
4 Click Apply. You’ll be notified
that Monarch HDX will be
rebooted in order to apply the
changes.
To Next Page
Loading...
