MAXA HI-T - Page 21

Hi‐TCentralizedcontroller
20
3.6.5.1 USERMENU–KEYBOARDSETUP
Toaccesstheusermenuyouhavetosettheuserpassword(modifiable):0.
Fromhereyoucan:
• Setthedateandthetimebypressingon“Clock”(itappearsthescreenshowninFigure22);
• Setthelanguagebypressingon“Language”;
• Accesstothesetupofthekeyboard,pressingon“Parameters”.

Figure22.Dateandtimepagesettings.

Itispossibletochangethesetupofthekeyboardaccordingtotheparametersshowninthefollowingtable:

N. PARAMETERSNAME UNIT DEFAULTVALUE MINIMUMVALUE MAXIMUMVALUE
1/3 Userpassword Numb 0 0 999
2/3 IdleBacklightintensity % 5 0 100
3/3 ScreensaverunlockPsw Numb 0 0 999
Table3.User’sparametersmenu(keyboardsetup).

Tochangethevalueofaparameter:
• entered in "Parameters", use the up and down arrows to scroll through the pages of the parameters, until you find the
desiredparameter;
• pressonthecurrentlysetvalue;
• thepresentvalueturnsredtoindicatethatitcan
bechangedbyusingtheupanddownarrows;
• selectthedesiredvalueandpresstheconfirmationtick.
• 

Note:Ifyoupressoutsidetheconfirmationarea,itreturnsagainthepreviouslyvalue.

3.6.5.2 SERVICEMENU
Toaccessthemenu,youmustsettheservicepassword.
Fromhere
youcan:
• configurethenetwork,bypushingon"Addressconfiguration";
• configurezones,bypushingon"AreaConfiguration";
• accesstoservice’sparametersChiller,Hi‐TandFancoil,pressingon"Parameters";
• accesstothealarmhistory,bypushingon"Alarmlist".

Thescreens
shownareasfollows:
1. Addressconfiguration
1.1. Addressesassigns
1.2. Scannetwork
2. Areaconfiguration
2.1. Zone01
2.2. Zone02
2.3. Zonexx
3. Maintenanceparameters
3.1. Chiller
3.1.1. Chiller01