MAXA HI-T - Page 28

 Hi‐TCentralizedcontroller
27
1. Enterthe“Settingsstatus”,thenin“Sanitarymode”;
2. On the next screen select "All" to enable all the chiller to the production of sanitary water, or select only the chiller
interestedinthisproduction(theotherwillbeusedexclusivelyfortheplant);
3. Confirmbypressingthetick
confirmationintheupperrightarea;


Figure23.Chillerchoiceforsanitarywater.


4. Inthe"System"menu(systemmainpage‐>" Statussetup"‐>"System"),withthesanitarymodeenabledbytheparameter
H10,itappearsalsothewords"Winterandsan","Summerandsan","Sanitary".






5. If the status of
the system is set to "Summer and san" or "Winter and san", the priority is given on the production of
domestichotwater;thereforethesystem goesfirstin domestichot waterproduction,when thesanitaryissatisfied, the
systemswitchesthemodetosummerorwinteroperation.

(*)Iffrom:Systemmainpage‐>"Statussetup"‐>"System"youselectonlythe"Sanitary":
toputthesanitaryin"OFF"or"Programmed"or"Manual"mode,thengoto"Statussetup",enterto"Chiller"andfromthereselect
thestatus(inthiscase
both"Manual"and"Manualeco"setthechillerinthesanitarymanualmode).





Note:Oncethe statusis set,you mustwait aminute toensure thatcommunicationwith theon‐board controloftheunits inthe
networkisgoingandtheunitsthemselvesareactivated
inthesetstatus.
CHILLER(*)
OFF PROGRAMMED MANUAL MANUALECO
WINTER
SYSTEM
SUMMER SUMMERANDSAN. WINTERANDSAN. SANITARY(*)
OFF PROGRAMMED MANUAL MANUALECO
OFF PROGRAMMED MANUAL MANUALECO