MAXA HI-T - Page 51

Hi‐TCentralizedcontroller
50
Ductedtype:
Seetheuser–installermanualtogetinformationasfortheductedtypewiringdiagrams.
HCN09
The dashed lines show the connections to be carried out by the installer.
All lines have to be protected at the origin by the installer.
YV1
Air sensor
Water sensor
Window
contact
med. speed
min. speed
N
L
out 1
N
out 2
+
gnd
-
RS485
1
2
+
gnd
-
max. speed
Black=Hight speed
Blue=Medium speed
Red=Low speed
White=Neutral
Yellow-Green=Ground
230V
50Hz
L=line
N = neutral
ground
HCN 09
HNS box
“out 2” terminal not used
As for the RS485 terminal board, see the “signal wiring connection” section.
Picture3.HNSboxconnectionwithHCN09
.HCN09withSBCmodule(V2valve)
V1
V2
Window
contact
Water sensor
Air sensor
m ed. speed
min. speed
N
L
out 1
N
out 2
+
gnd
-
RS485
1
2+
gnd
-
max. speed
Black = Hight speed
Blue = Medium speed
Red = Low speed
White = Neutral
Yellow-Green =Ground
230V
50Hz
L=Line
N=Neutral
Ground
As for the RS485 terminal board, see the “signal wiring connection” section.
The dashed lines show the connections to be carried out by the installer.
All lines have to be protected at the origin by the installer.
HCN 09
HNS box
Factory connections
Picture4.HNSboxconnectionwithHCN09withSBCmodule(V2valve).