11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
16
STEP 1 - ATTACH EXTENSION PLATE TO VEHICLE
1. Mark and drill holes into rear sill as shown in FIGS. 16-1 and 17-1.
REAR SILL - HOLE LOCATIONS FOR 96” WIDE VEHICLE
FIG. 16-1
USE 9/16” DRILL
(19 PLACES)
1-1/4”
3-1/8”
REAR
SILL
1-1/2”
19”
24”
14”
34”
41”
48”
55”
62”
72”
77”
82”
94-1/2”
96”
BOLT EXTENSION PLATE
NOTE: Liftgate extension plate comes with bolt holes so it can be bolted to vehicle
body with optional bolt kit. GRADE 8 bolts are required. MAXON recom-
mends getting the optional extension plate hardware kit listed in OPTIONS
section. Vehicle body must be drilled according to instructions. Extension
plate may also be welded to vehicle body. Do the following bolting or weld-
ing instructions for the extension plate.
CAUTION
To preserve the corrosion-resistant properties of the galvanized fi nish,
MAXON recommends bolting the galvanized extension plate to vehicle.
CAUTION
6-1/2”
6-1/2”
1-1/2”
1-1/4”
To Next Page
Loading...
