11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
38
STEP 7 - INSTALL CONTROL SWITCH
1. Measure, mark and drill one 3/4“ hole and two
#21–size holes in the vertical post on curb side
of vehicle body as shown in FIG. 38-1.
DRILLING MOUNTING HOLES
FIG. 38-1
VEHICLE BODY
VERTICAL POST
(CURB SIDE)
3/4” HOLE
VEHICLE BODY
VERTICAL POST
2. Insert control switch wir-
ing harness (parts box) into
3/4” hole on corner post and
down the vertical post and
under the vehicle body to
the pump assembly. (See
dashed line - FIG. 38-2.)
CONTROL
SWITCH
SELF-TAPPING
SCREW
(2 PLACES)
ROUTING CONTROL SWITCH WIRING
FIG. 38-2
3. Push control switch and
cable back into the 3/4” hole
in the vertical post until con-
trol switch touches the post
(FIG. 38-2). Attach control
switch to vertical post with
2 self-tapping screws (parts
box) (FIG. 38-2).
4. If necessary, use
clamps and self-tapping
screws (parts box) to
secure switch cable to
vehicle under-body and
frame (FIG. 38-2).
To Next Page
Loading...
