Maxon GPTLR-44 - Step 10: Remove Locking Brackets & Check Interference; Checking Platform to Extension Plate Gap

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
47
STEP 10 - REMOVE LOCKING BRACKETS & CHECK
FOR INTERFERENCE - Continued
8. Raise the platform to vehicle fl oor level
(FIG. 47-1). Refer to operating instruc-
tions in Operation Manual. Check for
5/8” gap between platform and edge of
extension plate (FIG. 47-1).
PLATFORM
EXTENSION
PLATE
NOTE: Correct any fi t and interference problems before continuing with installation.
CHECKING GAP BETWEEN PLATFORM
AND EXTENSION PLATE
FIG. 47-1
5/8” +/- 1/8”
5/8” +/- 1/8”