30
The Soak Sequence
Menu Item Description Default Limits
Temperature The water temperature 104°F
(40°C)
33.8–113°F
(1–45°C)
Inlet The suggested Inlet Valves are related to the
temperature and the Soap Box to be used.
IMPORTANT: If you insert Inlet Valves other than those
suggested, problems can occur at the water fill process.
11–17 11–18
Level The suggested water level depends on the Machine Type. Normal
Low
See Table A-3
RPM The suggested RPM depends on the Machine Type. – See Table A-5
Detergents Menu…
Supply 1, …, 8
Time selection for external liquid soap supplies.
You can program up to 4 supplies at the same time.
If you have programmed more than 4 supplies an error
message will be generated.
Reset the time of the supplies back to 0. Only 4 non-zero times
values can be programmed.
– Liquid soap supplies must be switched on in the
Configuration Menu.
0 sec 0–99 sec
On Time The wash action, motor On Time.
(The suggested default values can be adjusted at the
Initialization Menu)
12 sec 1–99 sec
Off Time The wash action, motor Off Time.
(The suggested default values can be adjusted at the
Initialization Menu)
10 min 1–99 min
Time The Soak Sequence Time.
(for 0 minutes the Soak Sequence will be skipped)
(programmable in steps of 0.1 minutes)
1 hour 0–25.5 hour
Signal When a signal is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for
the next step. A buzzer signal warns the operator that the cycle
has been interrupted.
No No/Yes
Prewash Wash Cool Down Rinse Final Rinse Soak Spray No Wash
To Next Page
