7
GENERAL CONTROL DESCRIPTION
The control offers:
n 99 programmable cycles
n 20 pre-programmed cycles
n Signal voltage control for external pumps or liquid supply
dispensers
n Redistribution of garments, if needed, to avoid imbalance
n Automatic temperature control during the water fill process
n Customization of wash options and configuration
n Multiple languages (one at a time)
Information displayed during operation:
n Program selected
n The active wash step
n The remaining program time
n Wash cycle progression bar
n Indication of wait for heat (if selected)
n Diagnostic messages
Operation Menu:
n Manually shorten, extend, or stop a cycle
n Pause a cycle
n Special function keypads allow direct operation of selected
components (water valves, etc.)
n Program overview
n Service information
THE HARDWARE AND SOFTWARE OF THE
WASHER COMPUTER:
n Easy operation using a comprehensive keypad
n The hardware contains 2 electronic boards
n The washer computer with Graphic LCD display
n Washer control software is stored as Flash memory
that is easily replaced
n Washer programs are stored as EEPROM memory
(non-volatile memory)
Control Features
Menu Functions
The PROGRAM Menu allows you to:
n Create and name wash programs
n Create and implement new wash programs step by step
n Edit existing wash programs
n Insert and delete steps in wash programs
n Copy wash programs
n Delete wash programs
n Inspect wash programs with the VIEW function
The CONFIGURATION Menu allows you to:
n Select the Machine Type
n Load the default factory settings into the CONFIGURATION
and INITIALIZATION Menu
n Select the display brightness
n Select the power supply voltage of the washer
n Load the Frequency Inverter Parameters
n Erase all the programmed wash programs
(reset Wash program in EEPROM memory)
n Load the standard wash programs
n Select the number of washer water supply inlets
n Select a second drain valve for water recycling
n External liquid pump setup (if connected)
n Select the temperature display (Celsius or Fahrenheit)
n Select full heating
n Select wet cleaning option (very low programmable water levels)
n Select the minimum water level for chemical supply to start
The INITIALIZATION Menu allows you to:
n Select display language
n Program the Service due cycle count
n Set buzzer time interval
n Select/deselect the Advance function
n Select/deselect the Wait for temperature function*
n Select/deselect manual override of a step or function
n Select/deselect the Temperature balance function*
n Select/deselect the default motor on and off times for reversing
wash cycle action
n Select/deselect the Automatic Cool Down function
n Program the hot water supply temperature
n Program the Temperature Overshoot Protection temperature
n Program the Maximum Heating Time
n Program the Maximum Fill time
n Programming the Maximum Level Overfill value
The SERVICE Menu allows you to:
n Inspect the error messages log register and statistics
n Activate the power of the Frequency Inverter
n Determine the functionality of the electric input signals
n Reset the Cycle counter
The DIAGNOSTIC Menu runs a diagnostic cycle to detect problems
with the washer
The ADVANCED Menu is designated for special optional
applications.
* For proper functioning, settings must be changed during initial
washer installation.
To Next Page
Loading...
