Dolphin Liberty | User Instructions
17
10. TROUBLESHOOTING GUIDE
Before contacting your Dolphin dealer, please read through this guide.
Problem Solution
The robot is moving in circles or
does not reach all areas of the pool.
1. Check that no foreign objects are blocking the moving parts.
2. Make sure the filter cartridge is clean and well-mounted and that
the filter doors are closed.
3. Before using the robot at the beginning of the season, brush any
algae from the floor and walls of the pool.
The robot is not moving sideways on
walls.
Adjust the diagonal angle of the handle.
The robot does not climb walls. 1. Clean the filter cartridges.
2. If this is the beginning of the season, use the spring cartridge.
3. Check if brushes are worn and replace them if necessary.
4. Make sure the impeller area is clean.
5. Check that the remote control is set for climbing.
Dolphin is not sinking. If using Wonder brushes or the combined brushes make sure they are
soaked in water.
Remote control unit is not working. Check if the batteries need to be replaced.
The robot stops working before
completing the cleaning cycle.
1. Check if the impeller is blocked.
2. Check if the drive system is blocked.
3. The battery may be empty; charge the robot.
If none of the above help, please contact your dealer.
The “No connection” LEDs are lit
when charging.
Check that the charging cable is connected properly and that the
connectors are dry. Wait 10 seconds and try again.
The green light on the float remains
on after the robot has finished a
cleaning cycle.
The charging contacts on the float are wet. Dry the contacts before
charging.
When the on button on the float is
pressed the robot does not begin to
work and the red LED flashes.
The battery is empty. Recharge the battery.
To Next Page
Loading...
