McCrometer WATER SPECIALTIES FlowCom FC101 - FC101 FlowCom Register Programming; Accessing Programming Configuration Menu

30119-50 Rev. 2.2 | 23JUL2020
Page 18
PROGRAMMING
4.0 PROGRAMMING
4.1 Accessing The Conguration Menu
Hold the magnetic wand as noted in Figure 27 below. After ve seconds the register will display “Loc-Code”. A lock code of
01000 is required to enter the conguration menu. Use the magnetic wand to input the lock code and then pass the
wand over the “P” symbol to submit the lock code and the conguration menu will appear. The register will switch back to
run mode by either selecting the run mode from the conguration menu or by not activating the conguration menu for
sixty seconds.
Figure 16. Magnetic Wand Activation Points For Conguration Menu
4.2 Document Changes
Each register ships with two silver identication labels. The label contains basic setting information for the register. If
changes are made to the register settings the labels should be marked as required. Forward the changes to the factory so
the records can be updated.
P
Magnetic Activation Point for
Conguration Menu Access
Approx. 7/8”
Loc-Code
NOTE: The lock code
“Loc-Code” is 01000