30119-50 Rev. 2.2 | 23JUL2020
Page 39
WARRANTY STATEMENT
Manufacturer warrants all products of its manufacture to
be free from defects in workmanship and material under
normal use and service. This warranty extends for a period
of twelve (12) months after date of shipment, unless
altered by mutual agreement between the purchaser and
manufacturer prior to the shipment of the product. If
this product is believed to be defective, purchaser shall
notify manufacturer and will return the product to the
manufacturer, postage paid, within twelve (12) months
after date of shipment by the manufacturer. If the purchaser
believes the return of the product to be impractical,
manufacturer shall have the option, but will not be required,
to inspect the product wherever located. In any event, if the
purchaser requests the manufacturer visit their location,
the purchaser agrees to pay the non-warranty expenses
of travel, lodging and subsistence for the eld service
response. If the product is found by the manufacturer’s
inspection to be defective in workmanship or material, the
defective part or parts will either be repaired or replaced,
at manufacturer’s election, free of charge, and if necessary
the product will be returned to purchaser, transportation
prepaid to any point in the United States. If inspection by
the manufacturer of such product does not disclose any
defect of workmanship or material, manufacturer’s regular
service repair charges will apply. Computing devices sold
but not manufactured by McCrometer, Inc. are covered only
by the original manufacturer’s written warranty. Hence, this
warranty statement does not apply.
THE FOREGOING WARRANTY IS MANUFACTURER’S SOLE
WARRANTY, AND ALL OTHER WARRANTIES, EXPRESS,
IMPLIED OR STATUTORY, INCLUDING ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, ARE NEGATED AND EXCLUDED.
THE FOREGOING WARRANTY IS IN LIEU OF ALL OTHER
WARRANTIES, GUARANTEES, REPRESENTATIONS,
OBLIGATIONS OR LIABILITIES ON THE PART OF THE
MANUFACTURER.
Purchaser’s sole remedy and manufacturer’s sole obligation
for alleged product failure, whether under warranty
claim or otherwise, shall be the aforestated obligation
of manufacturer to repair or replace products returned
within twelve months after date of original shipment. The
manufacturer shall not be liable for, and the purchaser
assumes and agrees to indemnify and save harmless
the manufacturer in respect to, any loss or damage that
may arise through the use by the purchaser of any of the
manufacturer’s products.
If you experience problems with your FlowCom register,
please contact your local factory representative for
assistance. You may also contact Customer Service at the
factory directly at 951-652-6811. Be prepared to provide
the serial number o of your meter or FlowCom register
(this information is located on the lid of the register).
When returning McCrometer products to the factory for
repair or warranty consideration, a return authorization
number (RA) must be obtained from the factory and
referenced on the outside of the box of the products you
are returning. The products should be shipped back to the
factory at:
McCrometer
3255 West Stetson Avenue
Hemet CA 92545
WARRANTY STATEMENT
To Next Page
Loading...
Need help?
General
