30119-50 Rev. 2.2 | 23JUL2020
Page 20
PROGRAMMING
4.4 Menu Navigation
NOTE:
1. If a lock code has been programmed then the user will be asked for the code upon entering into programming
mode. The factory default lock code is 01000.
PROGRAM Screen activated while in Run Mode by activating "P" reed switch for approximately 5 seconds.
Screen
Name
As
Displayed
"Rate" line
"Totalizer" line
....
.......
P
Reed Switch Icons
P
Hold for 5
seconds
First Menu Level
Program
Lock Out
Loc-CodE
P
Blink Off, Save
Change Digit.
Digit blinks until selected.
Move Cursor Left to next
digit position.
P
9
8
7
6
5
4
3
2
1
0
Display
To Rate Unit/
Time Menu
Show "Loc-CodE" on Totalizer line.
Blink “0” on Rate line.
If
saved code = 0
Or
saved code = entered
value
No
Exit to run mode
Note:
1. If a lock code has been programmed then the user will be asked for the code upon entering into
programming mode.
Default is 01000.
UP arrow cycles
through each
digit.
LEFT arrow
moves to next
digit location,
from right to left.
First Menu Level
0 Loc-CodE
To Next Page
Loading...
Need help?
General
