23
How to Operate by Remote Control
The supplied Remote Control is capable of directly control-
ling the functions of contemporary McIntosh Source Com-
ponents connected to the C2200. Earlier McIntosh source
components and other brand source components can be con-
trolled by the C2200 Remote Control with the addition of a
McIntosh Remote Control Translator (RCT).
Note: Your McIntosh Dealer can assist you with the
installation and operation of the Remote Control
Translator (RCT).
Mute
Press the MUTE Push-button to mute audio at the all the
Preamplifier Outputs, except the TAPE OUTPUTS. Press
MUTE a second time to unmute audio.
Mono
Press the MODE Push-button to combine Left and Right
Stereo Signals to Mono at all the Preamplifier Outputs, ex-
cept the Tape Outputs.
Trim and Level
Press the TRIM Push-button to active the Input TRIM
Function. Press the LEVEL UpS and DownT Push-but-
tons to Trim the Input Sound Level. For additional informa-
tion refer to page 15.
Input Source Selection
Press any of the eight Input Push-buttons to select a pro-
gram source.
CD/Tape Functions
Use these push-buttons to operate a CD Player, CD
Changer or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets or CD tracks/discs.
Disc and Track
Use the DISC and TRACK Push-buttons when a CD player
or changer is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel UpS or
DownTPush-button to move from station to station. Press
and hold a Channel UpS or DownT Push-button to move
continuously from station to station. Press +10 Push-button
to start the automatic brief audition of each of the presets
stored in the tuner memory. Press +10 Push-button a second
time to stop on a station preset and exit the review process.
Volume
Press the UpS or DownT VOLUME Push-button to raise
or lower the listening volume level.
Note: The TAPE OUPUTS are not affected by volume
changes.
Amplifier Selection
Press the 2nd Push-button followed by the Output 1 or 2
Push-buttons to control the rear panel OUTPUTS 1, 2
which can feed signals to a power amplifier or other acces-
sory component.
Acc On
Press ACC ON to turn the power ON to a McIntosh Disc
Player.
Acc Off
Press ACC OFF to turn the power OFF to a McIntosh Disc
Player.
Pause
Press to perform various functions on a variety of McIn-
tosh Components. It will also pause the playing of a Disc or
Tape Player.
How to Operate by Remote Control
To Next Page
Loading...
Need help?
General
