15
How to use the Remote Control
How to use the Remote Control
The supplied HR072 Remote Control is capable of
directly controlling the functions of contemporary
Source Components connected to the MA8000 via the
Data Ports.
Notes: 1. If at any time the MA8000 seems unrespon-
sive to HR072 Remote Control Commands
press the Push-button first.
2. For additional information on using the
HR072 Remote Control with the MA8000,
please refer to the “How to Operate” section
of this Owner’s Manual starting on page 24.
Input Source Selection
Press the appropriate Source Push-button to select the
desired program source.
Note: When the MA8000 is Off, pressing one of the
Source Push-buttons will switch the MA8000 On
and it will go to that Input.
Mute
Press the MUTE Push-button to mute the audio in all
outputs except the REC OUTPUT. The word MUTE
will appear on the Front Panel Display. To un-mute the
audio, press the MUTE Push-button again.
Disc, Server and Recorder Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner sta-
tion presets, tracks on discs or selections on a Music
Server.
Disc and Track
Use the AM (disc) and FM (track) Push-buttons when
a Disc Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Seek Up : the
band or Seek Down 9 the band Push-button to seek
the next available station. Press and hold a Directional
Up p or Down q Push-button to tune continuously
from station to station.
Volume
Press the VOLUME Up p or Down q Push-button to
raise or lower the listening volume level.
Note: The Record Signals present at REC OUTPUTS are
not affected by volume changes.
Pause
Press the Pause Push-button to perform various
functions on a variety of McIntosh Components. It
will also pause the playing of a disc or tape player.
Trim
Press the TRIM Push-button until the desired Trim
function (Balance, Trim Level, etc.) appears on the
Front Panel Display, then press the LEVEL Up p or
Down q Push-button to adjust the Trim setting.
Note: Press the TRIM Push-button to recall the last Trim
function selected. For additional information on
the Trim Functions refer to page 24 thru 27.
Amplifier Selection
Press the BLUE (Setup) Push-button followed by the
AM (Output 1) or FM (Output 2) Push-button, to con-
trol the rear panel Audio OUTPUTS 1, 2 (ON or OFF)
and Power Control TRIG 1 / TRIG 2. These OUT-
PUTS provide signals to the MA8000 Power Ampli-
fier and/or other accessory component.
Note: Refer to SETUP on page 20 “Power Control
Triggers 1 and 2 to change the default setting of
“MAIN” to “REMOTE”.
To Next Page
Loading...
Need help?
General
