19
Note: When direct accessing the “MY-PHONE”
Input using the Remote Control, press the AUX
Pushbutton.
Record any changes made to the various default Input
Names in the following chart for future reference.
8. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display.
Source Input Renaming
Default Input Name New Input Name
TUNER
CD
CD2
DVD
AUX
SRVR (Rec)
PHONO (MC)
PHONO (MM)
2. Press and hold the VOLUME Control until the
character “A” of the name AUX starts flashing.
Refer to figure 9.
3. Rotate the VOLUME Control until the character
“M” appears. Refer to figure 10.
4. Press the the VOLUME Control until the character
“U” starts flashing. Refer to figure 11.
5. Rotate the VOLUME Control until the character
“Y” appears. Refer to figure 12.
6. Repeat steps 3 thru 5 until the new name of “MY-
PHONE” is indicated on the Front Panel Display.
Refer to figure 13.
7. To save the new Input Name press and hold the
VOLUME Control until the word SAVED appears
momentarily on the Front Panel Display. Refer to
figure 14.
The MA8000 Default Input Names (CD, AUX, DVD,
etc. as indicated on the Front Panel Display) can be
customized with a different name up to nine charac-
ters long (My Phone, MCD1100, etc.). The available
characters for renaming the input include the follow-
ing: ! < > * , / - _ 0 1 2 3 4 5 6 7 8 9 A B C D E F G H
I K L M N O P Q R S T U V W X Y Z .
In the following example, the AUX Input will be re-
named to “MY-PHONE”.
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode is
active. Then rotate the INPUT CONTROL and
select the Setup Menu item “SETUP: SOURCE
NAME, AUX >> AUX”. Refer to figure 8.
Note: If the AUX Input is not displayed, press the
VOLUME Control repeatedly until it is dis-
played.
Input and Power Control Settings
Input Name Connec-
tion Type
New Level
(Trim)
Triggers
1 2
TUNER
CD
CD2
DVD
AUX
SRVR (Rec)
PHONO (MC)
PHONO (MM)
Setup, con’t
Figure 8
To Next Page
Loading...
Need help?
General
