11
How to use the Remote Control
Manual Tuning
Press the directional up or down buttons on the
inner ring of the remote to navigate incrementally
through stations.
Automatic Tuning
Press the SEEK 9 down or 10 up to move to the
next station.
Pre set Tun ing
Press the PRESET 8 down or 11 up button and
the MHT300 will stop on the next Station in preset
memory.
Note: For information on entering a station into memory, refer to
“Presets Edit” on page 28.
Setting a Preset
Once the FM station has been tuned, press the
PRESET button 16 to store this station into memory.
Erasing a Preset
Tune in the station preset and press the PRESET
button 16 to erase from memory.
Remote Control Batteries
The HR085 Remote Control included with the
MHT300 is powered by two AAA batteries. To insert
or remove batteries, open the battery compartment
by removing the cover located on the back of the
remote control. To open, pull the clasp located just
above the opening downward.
Additional Discrete Commands
Additional discrete commands for external control
systems are available:
• OPT1
• OPT2
• COAX1
• COAX2
• TUNER
• HDMI1
• HDMI2
• HDMI3
• HDMI4
• HDMITV
• Power (Cycle)
These additional commands can be accessed using
an optional McIntosh HR093 Service Remote Control.
A list of these commands as well as Pronto Hex Codes
can be found in the MHT300 Pronto Hex Codes
document located in the Download section of the
MHT300 product information at
www.mcintoshlabs.com
You can also contact McIntosh Technical
Assistance or your dealer for more information.
To Next Page
Loading...
Need help?
General
