5
Custom Installation
Remove the four feet when installing the MHT300 and retain them with the fastening screws
for possible future use. Do not install the MHT300 above heat generating components. When
the MHT300 is installed in a cabinet with other components, use a ventilation fan to provide
cool operating temperature.
• 3 inches (7.6cm) above the top
• 3 inches (7.6cm) below the bottom
•
•
Rack Mounting
To rack mount the MHT300, the two included side rack mounting brackets should be
installed.
Follow these instructions for each side:
1.
Remove the two screws from the front side of the MHT300’s side panel. Save these for
future use if the mounting brackets are removed.
2. Secure the side rack mounting bracket to the MHT300 using the larger supplied screws.
Do not re-use the previously removed screws. Use the smaller supplied screws to secure
the bracket to the front panel.
Trademark and License Information
The McIntosh MHT300 incorporates copyright protected technology
that is protected by U.S. patents and other intellectual property rights.
The MHT300 uses the following technologies:
Trademark Logo License Information
Dolby, Dolby Atmos, and the double-D
symbol are registered trademarks of Dolby
Laboratories Licensing Corporation.
Manufactured under license from Dolby
works. Copyright © 2012-2020 Dolby
Laboratories. All rights reserved.
Multimedia Interface, and the HDMI Logo
are trademarks or registered trademarks of
HDMI Licensing Administrator, Inc.
Manufactured under license from Dirac
Live. Dirac Live, Dirac
®
and Dirac Live
®
are
trademarks owned by Dirac Research AB.
For DTS patents, see http://patents.dts.com.
Manufactured under license from DTS
Licensing Limited. DTS, DTS:X, and the
DTS:X logo are registered trademarks or
trademarks of DTS, Inc. in the United States
and other countries. © 2021 DTS, Inc. All
rights reserved.
Front Panel
Side Panel
Side Rack
Mounting
Bracket
Larger
Supplied
Screws
Smaller Supplied
Screws
Front Panel
Side Panel
To Next Page
Loading...
Need help?
General
