29
Pre set Tun ing
To navigate the MHT300’s stored preset stations,
use either the PRESET REVERSE ( |<< ) or the
PRESET FORWARD ( >>| ) buttons to navigate up
and down the next station stored in preset memory.
105.70MHz ST
AUTO
-
39.0
P0
1
105.70MHz ST
AUTO
-
39.0
P01 = preset stored station #1
1-30 presets available to store
ST = “Stereo” radio signal vs “Mono”
Signal Strength
1
= Weak or none
2 = Medium
3 = Strong
AUTO = Surround mode
-39.0 = Volume
Navigating the Tuner Input
Selecting Tuner Input
The tuner input may be selected using the INPUT
knob or the remote control’s FM button.
Note: If the user selects tuner using the INPUT knob, they must
press it briefly to enter the tuner control mode that allows
the INPUT knob to be used to change stations. Another brief
press and the knob returns to its previous state. This action
is only required for the tuner input actions.
Manual Tuning
Press the directional up or down buttons on
the inner ring of the remote control to navigate
incrementally through stations.
Alternatively, while on the tuner input, Pressing the
INPUT knob will activate and allow for navigation
through FM stations by rotating the INPUT knob.
Automatic Tuning
Press the SEEK forward (>>) or the SEEK reverse
(<<) buttons on the remote control to tune to the next
available station, dependent on signal strength.
Storing Preset Station
To store an FM station in memory, Tune the
MHT300 to the desired station. Using the remote
control, press the PRESET button, the MHT300 will
then store the station onto the next preset available
(1-30). Alternatively, pressing PRESET on a station
preset.
To Next Page
Loading...
