17
SETUP: GENERAL > TRIGGER
Trigger1 and Trigger2 can each be set to power on/
(see “Power Control Connectors” on page 8).
Each Trigger can be set to:
• Independent allows each individual input to be
is selected, connected components will receive a
power control signal to power on until the selected
• All On sets the power control setting of all inputs
to On. With this selection, any input will generate
a power control signal to be sent for that Trigger.
All On is a quick way to change all the inputs
to On. You can switch to Independent to set any
•
switch to Independent to set any individual input
to On.
When Independent is selected, you can select On or
SETUP: GENERAL > FIRMWARE
SETUP: GENERAL > RCLOCK
Remote Control lock when enabled (On) will
prevent the front IR sensor from receiving IR
commands from a remote control. The default for
detect a remote control’s IR data, set remote control
lock to OFF (the default).
SETUP: GENERAL > AUTO OFF
The MHT300 incorporates power save circuitry
to automatically place the MHT300 into the power
saving standby mode approximately 30 minutes after
there has been an absence of an audio input signal on
both channels.
When there is a power control connection between
-
•
HDMI 1
• HDMI 2
• HDMI 3
• HDMI 4
• HDMI TV
• Optical 1
• Optical 2
• Coaxial 1
• Coaxial 2
• Tuner
General Setup Menu (continued)
To Next Page
Loading...
