Page 44 SE
AC
Slab Series - Operator’s Manual
November 2022
Troubleshooting
Should you experience erratic operation or notice any malfunction while
operating this machine, discontinue use immediately.
Call for assistance and report the incident to your supervisor, and do
not use the machine until it has been checked by a trained, qualied
mechanic.
Machine functions will not operate
• Master disconnect turned on?
• Batteries properly connected?
• Batteries fully charged?
• Key Switch in proper position?
• Both Emergency Stop Switches reset?
• Function Enable Switch not activated?
• Hydraulic uid level low?
• Obvious uid leak or damaged component?
• Wires disconnected, broken, or loose?
• Diagnostic panel on?
• Platform Control Box Fault Code present?
• Contact MEC Technical Support or refer to service manual. Manuals are available free online
at www.MECawp.com.
Section 11 - Troubleshooting
Troubleshooting
To Next Page
Loading...
