Page 46 SE
AC
Slab Series - Operator’s Manual
November 2022Section 12 - Transport and Lifting Instructions
8. If you want to reset the brakes, turn the key switch to the “ground” position.
Driving or Winching onto or o of a Transport Vehicle
Always attach the machine to a winch when loading or unloading from a
truck or trailer by driving.
Read and understand all safety, control, and operating information found
on the machine and in this manual before operating the machine.
Before loading or unloading the machine, check that:
• The deck extension, controls and component trays are secure.
• The platform is fully lowered.
• All loose items have been removed.
Before driving or winching the machine:
• Attach the machine to a winch.
• Remove all machine tie downs. Remove wheel chocks.
Driving
• Turn the Base Key Switch to PLATFORM. Check that the Emergency Stop Switch is reset by
turning it clockwise.
• Enter the platform and reset the Platform Emergency Stop Switch.
• Test platform control functions.
• Select slow drive speed mode. Carefully drive the machine o the transport vehicle with the
winch attached.
Note: The brakes are automatically released for driving and will automatically apply when the
machine stops.
Winching
• Disengage brakes (see Free-wheel conguration for Winching or Towing on page 45).
• Carefully operate the winch to lower the machine down the ramp.
• Chock the wheels and engage the brakes.
ART_5030
Lifting The Machine With A Forklift
• Position the forklift forks in line with the forklift pockets.
• Drive forward to the full extent of the forks.
• Raise the machine 6 in / 15 cm and then tilt the forks back
slightly to keep the machine secure.
• Be sure the machine is level when lowering the forks.
Lifting the machine from the side may result in component damage.
To Next Page
Loading...
