Medi Capture MVR Lite - Page 3

MVR Lite-UG01-EN-200324-OB
<3>
MVR Lite User Guide - English
WARNING
To avoid risk of electric shock, this equipment must only be connected to a supply mains with protective earth.
Do not modify this equipment without authorization of the manufacturer.
To avoid risk of electric shock, replace the fuse only by qualied service personnel, and only with the type specied in
the user guide.
To reduce the risk of re or shock hazard, do not expose this equipment to rain or moisture, this device is designed for
indoor use only.
Do not connect / disconnect physical video connections when power is on. This device may get hot during operation,
especially at the bottom and rear. When changing physical video connections, wait until device has cooled down before
reconnecting device.
External equipment, intended for connection to signal input / output or other connectors, shall comply with UL/EN
60601-1 for medical electrical equipment. Anyone who connects equipment to the signal input part or signal output part
is conguring a medical system, and is therefore, responsible that the system complies with the requirements of medical
system standard IEC 60601-1-1.
Equipment not complying with UL/EN/IEC 60601-1 shall be kept outside the patient environment, as dened on the
systems standard.
CAUTION
To reduce the risk of re or shock hazard and annoying interference, use the recommended accessories only.
Do not use the images for diagnosis or evaluation purposes. The compression reduces the information of the picture
and is therefore not appropriate for diagnosis.
The MVR Lite is a Class I active medical device (Medical Devices Directive 93/42/EEC). It is important to observe
your obligations as the operator of this medical device to ensure its safe operation with no risk of danger to patients,
users or third parties. If no other local law is applicable, it is recommended that a safety and document test be
performed at least once every 2 years according to EN 62353. It is important to ensure that persons performing the
safety check have the necessary qualications.
After a strong electrical disturbance, like lightning or a strong electrostatic discharge, the output signal may shake,
change in color, or turn black. If you see these symptoms, restart the device by turning off the power, waiting a few
seconds, and then turning on the power.
USA FCC CLASS A:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules.
CANADA ONLY / CANADA SEULEMENT
Caution: This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set
out in the Radio Interference Regulations of the Canadian Department of Communications.
Attention: L’interférence radioélectrique générée par cet appareil numerique de type A ne dépasse pas les limites
éconcées dans le Règlement sur les perturbations radioélectriques, section appareil numérique, du Ministère des
Communications.
Disposal Method: Use your local regulations for proper disposal.