Mark V ProVis Injection System
16 - 8
Control Unit - Electronics Console Access
Control Unit
Disassembly
Pedestal System:
1. Remove AC power, then secure the position of the injector by
locking the wheels.
2. Loosen the two captive thumbscrews that secure the right rear
access cover to the internal console retaining bar.
3. Loosen the four captive thumbscrews that secure the rear access
covers, then remove the covers from the assembly.
3. Loosen the captive screw at the top of the console retaining bar,
then remove the bar from the assembly.
4. Disconnect all cables connected to the rear connector panel.
5. Carefully remove the electronics console from the assembly, and
position on a flat anti-static surface with the connector panel facing
downward.
Rackmount System:
1. Remove power from the injector.
2. Loosen the two screws (either slotted or 9/64” hex key screws) at
the top of the front panel.
3. Tilt the front panel downward.
Control Unit
Reassembly
Pedestal System:
1. Carefully position the electronic console in the pedestal assembly.
2. Re-establish all cable connections at the rear connector panel.
3. Install and secure the console retaining bar.
3. Install and secure the rear access panels.
Rackmount System:
1. Tilt the front panel upward, and close.
2. Secure the two screws (either slotted or hex key) at the top of the
front panel.
To Next Page
Loading...
