Medrad ProVis Mark V - Troubleshooting the Mark V ProVis System; Test Equipment and Setup

Troubleshooting Guide
15 - 1
Troubleshooting Guide
The following represents test equipment that may be needed to ser-
vice a Mark V ProVis system, depending on what is being repaired or
replaced.
Required Test
Equipment
• Digital voltmeter (DVM) (Fluke 87 or True RMS equivalent)
• Oscilloscope (for minor troubleshooting and calibration; not for
major repairs) (Tektronix 465 or equivalent)
• Leakage Tester (for checking line leakage)
• Stopwatch or Timer
• KSP 591
• 25-pin card/cable extender (for PSC and MSC Cards) -
MEDRAD part number 78101-01-AC-04
• 37-pin card/cable extender (for Power Drive Card) -
MEDRAD part number 78101-01-AC-05
• Service Access Card-
MEDRAD part number 85106-05-AP-01
• Portable Digital Timer -
MEDRAD part number KSP-141
• Pressure Gauge Assembly - MEDRAD part number KSP-135
15