Disassembly and Reassembly
16 - 31
Injector Head - Pivot Knuckle Adjustment
This procedure is to be performed if the injector head will not stay in
the position in which it was set.
Adjustment
Procedure
1. Remove the hole plug located on the side of the pivot knuckle.
2. Tighten the nut until the head will remain in the set position.
NOTE: If the pivot knuckle is secured by a bolt, avoid over-
tightening of the bolt to prevent stripping of the casting.
Stripping will result in slippage of the bolt, causing the
injector head to fall.
To Next Page
Loading...
