Zero adjustment procedure
Select “0-ADJ”.
The BITE5 will prompt you to make a zero adjustment bar.
Select YES.
NOTE: Place the probes on the zero adjustment bar as shown within 10 seconds of selecting YES, or the BITE5 will time
out.
This zero adjustment will begin. Hold probes on zero bar until adjustment is complete.
Operation
Configuration of BITE5
The BITE5 allows you to customize the unit for your needs. You can set the desired language, the date and time format,
the screen brightness setting, a unit and display auto off time out, temperature format, and the desired buzzer volume.
This screen also allows you to format the micro SD card and reset the unit to defualt conditions.
CONFIGURATION ICON
www.megger.com
BITE5
12
Configuration of BITE5
To Next Page
Loading...
Need help?
General
