Megger DLRO-10X - Repair and Warranty; Instrument Repair and Spare Parts

REPAIR AND WARRANTY
23
Duplex handspikes with replaceable Needle Points 2m/7 ft 242003-7
Duplex 1.27 cm (1⁄2”) Kelvin Clips. (2) gold plated 2m/7 ft 241005-7
silver plated 2m/7 ft 242005-7
Duplex 3.8 cm (11⁄2”) Kelvin Clips. (2) 2m/7 ft 242006-7
5.5m/18ft 242006-18
9m/30 ft 242006-30
Single Leads
Single handspikes (2) for potential measurement. 2m/7 ft 242021-7
5.5m/18ft 242021-18
9m/30 ft 242021-30
Current clips (2) for current connections. 2m/7 ft 242041-7
5.5m/18ft 242041-18
9m/30 ft 242041-30
The instrument circuit contains static sensitive devices, and care must
be taken in handling the printed circuit board. If the protection of
an instrument has been impaired it should not be used, and be sent
for repair by suitably trained and qualified personnel. The protection
is likely to be impaired if, for example, the instrument shows visible
damage, fails to perform the intended measurements, has been subjected
to prolonged storage under unfavourable conditions, or has been
exposed to severe transport stresses.
New Instruments are Guaranteed for 1 Year from the Date of
Purchase by the User.
Note: Any unauthorised prior repair or adjustment will automatically
invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact:-
Megger Limited or Megger
Archcliffe Road Valley Forge Corporate Centre
Dover 2621 Van Buren Avenue
Kent, CT17 9EN. Norristown, PA 19403
England. U.S.A.
Tel: +44 (0) 1304 502100 Tel: +1 (610) 676-8579
Fax: +44 (0) 1304 207342 Fax: +1 (610) 676-8625
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have been
approved for repair work on most Megger instruments, using genuine
Megger spare parts. Consult the Appointed Distributor / Agent regarding
spare parts, repair facilities and advice on the best course of action to
take.