2
SAFETY WARNINGS
• Test leads, prods and crocodile clips must be in good order; clean, and with no broken or
cracked insulation.
• Test leads must be disconnected from circuit under test before changing switch
positions.
• U.K. Safety Authorities recommend the use of fused test leads when measuring voltage
on high energy systems.
• Voltage measurement must not be attempted with test leads inserted in the A or mA/µA
terminals.
• If unsure of the required range, start with the highest range and work downwards.
• Circuit and test lead tips must not be touched during testing.
• Replacement fuses must be of the correct size, type and rating.
• Safety warnings and precautions must be read and understood before the instrument is
used. They must be observed during use.
NOTE
THE INSTRUMENTS MUST ONLY BE USED BY TRAINED AND COMPETENT PERSONS
To Next Page
Loading...
