Repair and Warranty
30
The instrument circuit contains static sensitive devices, and
care must be taken in handling the printed circuit board. If
the protection of an instrument has been impaired it should
not be used, and be sent for repair by suitably trained and
q u a l i fi ed personnel. The protection is likely to be impaired if,
for example, the instrument shows visible damage, fails to
perform the intended measurements, has been subjected to
prolonged storage under unfavourable conditions, or has
been exposed to severe transport stresses.
New instruments are guaranteed for 3 years from the
date of purchase by the user.
Note: Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger
®
Instruments
contact:–
Megger Limited or Megger
Archcliffe Road Valley Forge
Dover Corporate Center
Kent CT17 9EN 2621 Van Buren Avenue
English Norristown, PA 19403
Tel: 44+ (0) 1304 502243 U.S.A.
Fax: 44+ (0) 1304 207342 Tel: +1 (610) 676-8579
Fax:+1 (610) 676-8625
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies
have been approved for repair work on most Megger
instruments, using genuine Megger spare parts. Consult
the Appointed Distributor/Agent regarding spare parts,
repair facilities and advice on the best course of action to
take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it
should be sent freight pre-paid to the appropriate address.
A copy of the Invoice and of the packing note should be
sent simultaneously by airmail to expedite clearance
through Customs. Arepair estimate showing freight return
and other charges will be submitted to the sender, if
required, before work on the instrument commences.
To Next Page
Loading...
