To avoid electrical shock hazard or damage to the meter, do not exceed the overload levels shown below.
* 10A continuous; 20A for 30 seconds maximum, 5 minutes cool down
i n t e r v a l .
Table 1.
Safety
4
Function Terminals Overload Level
d.c. voltage
1000V d.c.
a.c. voltage & COM
V peak
d.c.+a.c. voltage
mV millivolt
ADPAdaptor
Hz Frequency
% Duty Cycle
Ω Resistance & COM 600V d.c. or
nS Conductance V a.c. rms
Audible Continuity
Capacitance
Diode Test
A Current A & COM 10A/600V*
mA or µACurrent mA, µA & COM 630mA/500V
Symbols used on the instrument
Caution: Refer to accompanying notes.
Risk of electric shock.
Equipment complies with relevant EU
Directives
Equipment protected throughout by
Double Insulation (Class II).
To Next Page
Loading...
