Megmeet MV300 Series - Page 103

103
P15.04
Response
delay of the
drive
Response
delay of the
drive
0~1000ms 1 5ms × √ ×
P15.05
Reserved
function 1
for user
Reserved
function 1 for
user
0~65535 1 0 × √ ○
P15.06
Reserved
function 2
for user
Reserved
function 2 for
user
0~65535 1 0 × √ ○
Group P16: Keyboard display setting parameters
P16.00
LED display
parameter
selection
1 when
running
Running
display 1
Binary setting:
0: No display; 1: Display
Unit place of LED:
BIT0: Output frequency (Hz)
BIT1: Preset frequency (Hz
flashing)
BIT2: Output current (A)
Tens place of LED:
BIT0: Running speed (r/min)
BIT1: Set rotating speed (r/min,
flashing)
BIT2: Running line speed（m/s）
BIT3: Preset line speed (m/s,
flashing)
Hundreds place of LED:
BIT0: Output power
BIT1: Output toque (%)
Note: the default display shall be
output frequency when all the
parameters are 0
1 007H × √ ○
P16.01
LED display
parameter
selection
2 when
running
Running
display 2
Binary setting:
0: No display; 1: Display
Unit place of LED:
BIT0: Output voltage (V)
BIT1: AI1（V）
BIT2: AI2（V）
Tens place of LED:
BIT0: Close loop feedback (%)
BIT1: Close loop reference (%,
flashing)
BIT2: Terminal status (without
unit)
BIT3: DC bus voltage
1 00 × √ ○
P16.02
LED display
parameter
selection wh
Stop display
Binary setting:
0: No display; 1: Display
Unit place of LED:
1 009H × √ ○