Megmeet MV300 Series - Keyboard Display Setting Parameters (Group P16)

202
This function code is used for marking the address of drive.
Note: 0 is the broadcast address. If it is set as the broadcast address, it can only receive and execute the
broadcast command from the host device, and will not respond to the host device.
When the serial port communication signal disappears for a period of time exceeding the set value of this
function code, the drive is considered as communication fault.
When the set value is 0, the drive will not detect the serial port communication signal.
The serial port of the drive receives and executes commands from the host device, until going back to the
delay time which the response frame gave to the host device. For the RTU mode, the actual response
delay shall be no less than the transmission time of 3.5 characters.
Reserved.
Reserved.
6.16 Keyboard display setting parameters (Group P16)
Fig. 6-71 Setting of LED display parameter selection 1 when running
P16.00 and P16.01 define the parameters that LED can display when the drive is in running state.
When 0 is selected for the BIT bit, it indicates that the parameter is not displayed.
When 1 is selected for the BIT bit, it indicates that the parameter is displayed.
LED dis
p
la
y
p
arameter selection 2 when runnin
g
0~F7H
(
00
)
P16.01
LED dis
p
la
y
p
arameter selection when runnin
g
0~3F7H
(
007
)
P16.00
Reserved function 2 for use
r
0~65535
(
0
)
P15.06
Reserved function 1 for use
r
0~65535
(
0
)
P15.05
Res
p
onse dela
y
of the drive 0~1000ms
(
5ms
)
P15.04
Communication timeout detection time 0.0~1000.0s
(
0.0s
)
P15.03
Local address 0~247
(
5
)
P15.02