Megmeet MV300 Series - Page 89

89
1: Current input
P10.01
Analog AI
function
selection
AI function
selection
Unit place of LED: AI1 function
selection
0: No function
1: Main reference frequency
setting
2: Auxiliary reference frequency
setting
3: Torque offset
4: Speed limit value 1
5: Speed limit value 2
6: Torque limit value 1
7: Torque limit value 2
8: Torque command (reference)
9: Main reference frequency
setting (unipolar)
A: Auxiliary reference frequency
setting (unipolar)
B: Motor temperature detection
C: Output voltage offset (under
V/F)
D: Output voltage (under V/F)
E: Reserved (command rate
numerator)
Tens place of LED: AI2 function
selection is the same as above
1 000 √ √ ×
P10.02 AI1 filtering AI1 filtering 0.000~10.000s 0.001s 0.010s × √ ○
P10.03 AI2 filtering AI2 filtering 0.000~10.000s 0.001s 0.010s × √ ○
P10.04 Reserved
P10.05
Analog
curve
selection
Analog curve
selection
Unit place of LED: AI1 curve
selection
0: Line 1
1: Line 2
2: Curve 1
Tens place of LED: AI2 curve
selection is the same as above
Hundreds place of LED: Reserved
Thousands place of LED: Pulse
input curve selection
Same as above
1 0010H √ √ ○
P10.06
Maximum
reference of
line 1
Maximum
reference 1
P10.08~100.0% 0.1% 100.0% √ √ ○
P10.07
Actual value
corresponds
to the
maximum
Actual value
corresponds
to maximum
reference 1
Frequency reference:
0.0~100.0% of Fmax
Torque: 0.0~300.0% of Te
0.1% 100.0% √ √ ○