7 Sterilization
29
2. For example, to change the time, tap directly on the
parameters Hour or Minutes. The selected field is
highlighted light blue.
3. Change e.g. the hour by pressing the pushbuttons
and .
4. Then press START. The display remains in the
start time pre-selection window.
Ê After the start of the start time pre-selection no other menu apart from the Info & Status menu can
be selected.
Starting the program
With the start of the program, the door closes pressure-tight and the steam sterilizer checks the quantity of
feed water and its conductivity.
1. To start a program, press the START key.
2. With activated user authentication:
Enter the user PIN or press (if possible) the button to
skip this stage (see User administration
[}page51]).
PLEASE NOTE: Only ever use the “Skip user
authentication” function in an emergency.
PLEASE NOTE
When starting Quick-Program S, a warning and an acoustic signal indicates that this
program is suitable only for the sterilization of unwrapped instruments. If the load
contains unwrapped instruments only, confirm with YES, to start the program.
To Next Page
Loading...
