3-1
INSTALLATION MA-5081-E B4 NS ADHESIVE MELTER MANUAL
3. INSTALLATION
Warning: The melters are equipment with current technology and with certain
foreseeable risks. Therefore, only allow qualified personnel with sufficient
training and experience to use, install or repair this equipment.
Introduction
The B4 NS melter is supplied with all the components required for its
installation. However, some components must be supplied by the user
depending on the location and connections in each specific installation:
• Melter anchoring screws
• Power cord for electrical power supply
• Pneumatic conduct and connection to compressed air network
• Stranded wire for external electric control functions
• Optionally, a gas venting system
Installation requirements
Before installing a B4 NS melter you must ensure that the space allocated is
suitable for the installation, connection and use of the entire system. You must
also ensure that the electrical and pneumatic supplies meet the requirements
of the melter being installed.
Free space
620
700
600
360
400
840
To Next Page
Loading...
