Melitta Caffeo Bistro - Inserting the Melitta Claris Water Filter

52
6 Inserting the Melitta
®
Claris
®
water lter
A Melitta
®
Claris
®
water lter is supplied with the appliance for ltering out lime scale
and other contaminants. Please only insert it after starting up the appliance for
the rst time. When using the lter, the appliance does not require descaling as
often, and the water hardness can be set to 1 (you can nd more information on
page 57). The service life of your appliance will be extended thanks to the reliable
protection from lime scale. The water lter should be changed regularly; however,
after two months at the latest.
• Set the current month on the blue ring on top of the Melitta
®
Claris
®
water lter. This way, you can easily see when it is time to change the
Melitta
®
Claris
®
water lter.
• Put the water lter in a glass with fresh tap water for several minutes
before you insert it.
• Lift the lid of the water tank (Fig. A, no. 3) and pull the water tank up
and out of the appliance.
• Empty the water tank.
• Carefully screw the Melitta
®
Claris
®
water lter into the thread on the
base of the water tank using the screw-in aid at the bottom end of the
coffee scoop provided.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
• Place a vessel under the Perfect Cappuccino and push the steam pipe
downwards until it is positioned below the brim of the vessel.
• Turn the valve switch (Fig. A, no. 6) clockwise to open the valve.
→ Water now runs into the vessel beneath the Perfect Cappuccino.
• As soon as the water tank symbol illuminates, turn the valve switch
anti-clockwise to close the valve.
→ The appliance is ready for operation.
Note
The Melitta
®
Claris
®
water lter should not remain dry over an extended period
of time. We therefore recommend storing the Melitta
®
Claris
®
water lter in
the refrigerator in a glass of water when the appliance will not be in use for
extended periods.