58
10.2 Setting the energy-saving mode
After the last action, the appliance automatically (depending on the settings)
switches to energy-saving mode (the appliance thus consumes much less energy
than in stand-by mode). You can set different times for the energy-saving mode.
The appliance is factory-set at 15 minutes .
Prerequisite: The appliance is in stand-by mode (see „Switching on and off“
on page 51).
Please set the energy-saving mode as follows:
• Press the buttons for one-cup dispensing and for steam dispensing
simultaneously until the four buttons are weakly illuminated.
• Press the button for coffee strength several times to select among
the four possible timer settings.
→ The button for coffee strength is brightly illuminated.
Your selection is shown with the bean symbols on the display.
Display Time
5 minutes
15 minutes
(factory setting)
30 minutes
OFF
• Press the ON/OFF button to conrm the selected time.
→ Depending on the selection, 1 to 4 bean symbols ash on the display as
conrmation. The appliance goes back to stand-by mode.
Note
You can wake up the appliance from the energy-saving mode by pressing any
of the buttons. The function of the pressed button (e.g. prepare coffee) will be
performed directly, only the heat-up phase takes a little longer.