Melitta Caffeo Bistro - Integrated Cleaning Programme

ENGLISH
65
11.4 Integrated cleaning programme
The integrated cleaning programme removes residues, including coffee oil residues,
that cannot be eliminated by hand. It takes a total of approximately 15 minutes. The
cleaning button ashes during the entire process.
For optimal cleaning results, we recommend that you clean the brewing unit
beforehand (see page 64).
Prerequisite: The appliance is in stand-by mode (see „Switching on and off“
on page 51).
Caution!
– Run the integrated cleaning programme every 2 months or after
approximately 200 brewed cups of coffee; at the latest, however, run the
programme when the symbol for cleaning lights up on the display.
– Only use Melitta
®
cleaning tabs for fully automatic coffee makers. These
cleaning tabs are designed specically for Melitta
®
CAFFEO
®
. The use of
other cleaning agents can damage the appliance.
Run the integrated cleaning programme as follows:
1 Remove the Melitta
®
Claris
®
water lter – if used – from the water tank
(see page 52).
2 Press the button for one-cup dispensing and the ON/OFF button
simultaneously for about 3 seconds.
→ The symbol for cleaning ashes.
The drip tray symbol illuminates.
3 Empty the drip tray and coffee grounds container.
4 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the outlet.
Phase 1
During Phase 1, one bean symbol is shown on the display.
→ First, two automatic rinsing processes are carried out.
The ground coffee chute symbol illuminates.