Rev. 1.733 Mellanox Technologies
Table 10 - Configuration Wizard Session
Wizard Session Display Comments
Mellanox configuration
wizard
Do you want to use the wiz-
ard for initial configuration?
yes
You must perform this configuration the first time you
operate the system or after resetting the system. Type ‘y’
and then press <Enter>.
Step 1: Hostname? [switch ] If you wish to accept the default hostname, press <Enter>.
Otherwise, type a different hostname and press <Enter>.
Step 2: Use DHCP on
mgmt0 interface? [no] yes
Perform this step to obtain an IP address for the system.
(mgmt0 is the management port of the system).
If you wish the DHCP server to assign the IP address, type
‘yes’ and press <Enter>.
If you type ‘no’ (no DHCP), then you will be asked
whether you wish to use the ‘zeroconf’ configuration or
not.
If you enter ‘no’ (no Zeroconf), you must enter a static IP,
and the session will continue.
Step 3: Enable IPv6? [yes] The management interface will be able to use IPv6
addresses.
Step 4: Enable IPv6 auto-
config (SLAAC) on mgmt0
interface? [no]
This turns on auto-configuration of the IPv6 addresses.
This is unsuitable for DHCPv6.
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
To enable DHCPv6 on the MGMT0 interface.
Step 6: Admin password
(Press <Enter> to leave
unchanged)? <new_pass
-
word>
Step 6: Confirm admin
password? <new_pass
-
word>
To avoid illegal access to the machine, please type a pass-
word and then press <Enter>. Then confirm the password
by re-entering it.
Note that password characters are not printed.
You have entered the fol-
lowing information:
<A summary of the configu-
ration is now displayed.>
To change an answer, enter
the step number to return to
or hit <enter> to save
changes and exit.
Choice: <Enter>
Configuration changes
saved.
The wizard displays a summary of your choices and then
asks you to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter the
configuration step number that you wish to return to.
Note:
To re-run the configuration wizard, run the command “con-
figuration jump-start” in Config mode.
To Next Page
Loading...
Need help?
General
