Rev 2.2 99Mellanox Technologies
6. Stacking the Chassis
7. Redundant Power Supply Connection - Electrical Hazard
8. Double Pole/Neutral Fusing
9. Multiple Power Inlets
10. During Lightning - Electrical Hazard
11. CopperCable Connecting/Disconnecting
12. Rack Mounting and Servicing
13. Equipment Installation
The chassis should not be stacked on any other equipment. If the chassis falls, it can
cause bodily injury and equipment damage.
This product includes a redundant power or a blank in its place. In case of a blank
power supply, do not operate the product with the blank cover removed or not securely
fastened.
This system has double pole/neutral fusing. Remove all power cords before opening
the cover of this product or touching any internal parts.
Risk of electric shock and energy hazard.
The PSUs are all independent.
Disconnect all power supplies to ensure a powered down state inside of the switch
platform.
During periods of lightning activity, do not work on the equipment or connect or dis-
connect cables.
Copper cables are heavy and not flexible, as such they should be carefully attached to
or detached from the connectors. Refer to the cable manufacturer for special warnings/
instructions.
When this product is mounted or serviced in a rack, special precautions must be taken
to ensure that the system remains stable. In general you should fill the rack with equip-
ment starting from the bottom to the top.
This equipment should be installed, replaced, and/or serviced only by trained and qual-
ified personnel.
To Next Page
Loading...
Need help?
General
