Section 5 - Maintenance
Page 66 90-864197076 NOVEMBER 2008
Filling
1. Remove the fill cap/dipstick and observe the level.
2. Add Quicksilver Power Trim and Steering Fluid or Dexron III Automatic Transmission Fluid (ATF) to bring the fluid level up to
the proper level.
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering
Fluid
Power steering system 92-858074K01
3. Reinstall the fill cap/dipstick.
Changing
Power steering fluid does not require changing unless it becomes contaminated with water or debris. Contact your authorized
Mercury MerCruiser dealer.
Engine Coolant
Checking
!
CAUTION
A sudden loss of pressure can cause hot coolant to boil and discharge violently resulting in serious injury from burns. Allow the
engine to cool down before removing the coolant pressure cap.
1. Remove the cap from the heat exchanger and observe the fluid level.
Heat exchanger cap
2. The coolant level in the heat exchanger should be at the bottom of the filler neck. If the coolant level is low, contact your
authorized Mercury MerCruiser dealer.
3. Install the cap onto the heat exchanger.
IMPORTANT: When reinstalling the pressure cap, be sure to tighten it until it seats on the filler neck.
4. With the engine at normal operating temperature, check the coolant level in the coolant recovery bottle.
To Next Page
Loading...
