Section 5 - Maintenance
90-864197076 NOVEMBER 2008 Page 89
Reference Electrode 91‑76675T 1
Senses and electrical current in the water when testing the MerCathode system.
Use to check hull potential.
Power Package Exterior Surfaces
1. Spray the entire power package at recommended intervals with Corrosion Guard. Follow the instructions on the can for proper
application.
Tube Ref No. Description Where Used Part No.
120
Corrosion Guard Painted surfaces 92-802878 55
2.
Clean the entire power package. External surfaces that have become bare should be repainted with the recommended primer
and spray paint at recommended intervals.
Description Part Number
Mercury Light Gray Primer
Painted surfaces
92‑802878 52
Mercury Phantom Black 92‑802878Q 1
Boat Bottom Care
To achieve maximum performance and fuel economy, the boat bottom must be kept clean. Accumulation of marine growth or
other foreign matter can greatly reduce boat speed and increase fuel consumption. To ensure best performance and efficiency,
periodically clean the boat bottom in accordance with manufacturer's recommendations.
In some areas, it may be advisable to paint the bottom to help prevent marine growth. Refer to the following information for special
notes about the use of anti‑fouling paints.
Anti‑fouling Paint
IMPORTANT: Corrosion damage that results from the improper application of anti‑fouling paint will not be covered by the limited
warranty.
You may apply anti‑fouling paint to the
boat hull and boat transom but you must observe the following precautions:
IMPORTANT: Do not paint or pressure‑wash the anodes or the MerCathode System reference electrode and anode. Doing so
will render them ineffective as inhibitors of galvanic corrosion.
To Next Page
Loading...
