Section 5 - Maintenance
Page 76 90-864197076 NOVEMBER 2008
6. Open fuel supply valve, if equipped.
7. Reconnect the Cool Fuel Module harness to the engine wiring harness.
8. Properly ventilate the engine compartment.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
9. Supply cooling water to the engine.
10. Start the engine. Check for gasoline leaks around the fuel filter assembly. If leaks exist, stop the engine immediately. Recheck
the filter installation, clean spilled fuel and properly ventilate the engine compartment. If leaks continue, stop engine
immediately and contact your authorized Mercury MerCruiser dealer.
Lubrication
Steering System
!
WARNING
Incorrect cable lubrication can cause hydraulic lock, leading to serious injury or death from loss of boat control. Completely
retract the end of the steering cable before applying lubricant.
NOTE: If steering cable does not have grease fitting, inner wire of cable cannot be greased.
1. If Steering Cable Has Grease Fittings: Turn steering wheel until steering cable is fully retracted into cable housing. Apply
approximately 3 pumps of grease from a typical hand‑operated grease gun.
a - Steering cable grease fitting
Tube Ref No. Description Where Used Part No.
34
Special Lubricant 101 Steering cable grease fitting 92-802865Q02
2. Turn steering wheel until steering cable fully extended. Lightly lubricate the exposed part of cable.
a - Extended steering cable
6221
a
a
6222
To Next Page
Loading...
