Section 5 - Maintenance
90-899883295 JUNE 2008 Page 93
Cleaning The Flame Arrestor
!
WARNING
Fuel is flammable and explosive. Ensure the key switch is off and the lanyard is positioned
so that the engine cannot start. Do not smoke or allow sources of spark or open flame in
the area while servicing. Keep the work area well ventilated and avoid prolonged
exposure to vapors. Always check for leaks before attempting to start the engine and
wipe up any spilled fuel immediately.
1. Remove the engine cover.
2. Loosen the flame arrestor clamp and remove the flame arrestor.
3. Clean the flame arrestor with solvent. Dry with compressed air or allow to air dry
completely.
8482
a
a - Flame arrestor
4. Install flame arrestor. Tighten the flame arrestor clamp.
5. Install the engine cover.
Water‑Separating Fuel Filter
!
WARNING
Fuel is flammable and explosive. Ensure the key switch is off and the lanyard is positioned
so that the engine cannot start. Do not smoke or allow sources of spark or open flame in
the area while servicing. Keep the work area well ventilated and avoid prolonged
exposure to vapors. Always check for leaks before attempting to start the engine and
wipe up any spilled fuel immediately.
To Next Page
Loading...
