Section 3 - On the Water
90-899883295 JUNE 2008 Page 65
• Press the "TRACK WAYPOINT" button on the Axius Premier touchpad. The
"TRACK WAYPOINT" button light goes off and Axius Premier goes to Standby.
The "STANDBY" light turns on
• Turn the steering wheel hard enough to overcome the detent and Axius Premier
features go into Standby.
• Move both ERC levers back to neutral and Axius Premier goes to Standby.
• Press either "TURN" button and Axius Premier goes to Auto Heading mode.
• Press the "AUTO HEADING" button and Axius Premier CAN touchpad goes to
Auto Heading mode.
• Turn off the chart plotter and Axius Premier goes to Standby.
2. You can resume the Track Waypoint heading within one minute, if the vessel has not
turned too far and the "RESUME" light is still on or flashing.
TURN BUTTONS OR JOYSTICK IN TRACK WAYPOINT MODE
While in "TRACK WAYPOINT" mode, press the left or right "TURN" buttons on the
touchpad or use the joystick to change the mode to "AUTO HEADING."
AUTO HEADING BUTTON IN TRACK WAYPOINT MODE
While in "TRACK WAYPOINT" mode, press the "AUTO HEADING" button to cause Axius
Premier to change to "AUTO HEADING" mode.
ACKNOWLEDGING A TURN DURING A WAYPOINT ARRIVAL
IMPORTANT: Track Waypoint mode does not automatically turn the boat upon arrival at
a plotted waypoint.
1. When the boat enters a waypoint arrival zone as indicated by the chart plotter, a short
horn beep sounds and the "WAYPOINT SEQUENCING" button light starts blinking to
inform the operator to make a turn.
a - Indicator light
b - "WAYPOINT SEQUENCE" button
To Next Page
Loading...
Need help?
General
