EasyManuals Logo

Mercury MERCRUISER Owner's Manual

Mercury MERCRUISER
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
Section 5 - Maintenance
Page 82 90-899883295 JUNE 2008
Engine Oil
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by
law. Use caution not to spill oil, coolant, or other fluids into the environment when using
or servicing your boat. Be aware of the local restrictions governing the disposal or
recycling of waste, and contain and dispose of fluids as required.
Checking
1. Stop the engine. Allow approximately 5 minutes for the oil to drain into the oil pan. The
boat must be at rest in the water.
2. Remove the dipstick. Wipe clean and reinstall fully into the dipstick tube. Wait 60
seconds to allow trapped air to vent.
NOTE: Ensure that dipstick is installed with oil level indication marks facing the rear of the
engine (flywheel end).
8481
a
a - Dipstick tube
IMPORTANT: Add the specified engine oil to bring the level up to, but not over, the full or
OK range mark on the dipstick.
3. Remove the dipstick and observe the oil level. Oil level must be between full or OK
range and add. Reinstall dipstick into dipstick tube.
Filling
IMPORTANT: Do not overfill the engine with oil.
IMPORTANT: Always use the dipstick to determine the exact quantity of oil or fluid required.

Table of Contents

Other manuals for Mercury MERCRUISER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury MERCRUISER and is the answer not in the manual?

Mercury MERCRUISER Specifications

General IconGeneral
Number of Cylinders4, 6, 8
Engine TypeInboard/Outboard (Sterndrive)
Fuel TypeGasoline
AspirationNaturally Aspirated
Cooling SystemWater Cooled
WeightVaries by model
Cylinder ConfigurationInline
Displacement Range3.0L-8.2L

Related product manuals