Section 5 - Maintenance
Page 106 90-899883295 JUNE 2008
IMPORTANT: If anti‑fouling protection is required for the boat hull or boat transom, you
can use copper‑based paint if it is not prohibited by law. If you are using copper based
anti‑fouling paint, observe the following precaution:
• Avoid an electrical interconnection between the Mercury MerCruiser Product, Anodic
Blocks, or MerCathode System and the paint by allowing a minimum of 40 mm
(1‑1/2 in.) UNPAINTED area on transom of the boat around these items.
8107
b
a
a - Painted boat transom b - Minimum 40 mm (1‑1/2 in.)
unpainted area around transom
assembly
NOTE: Sterndrive and transom assembly can be painted with a good marine paint or an
anti‑fouling paint that DOES NOT contain copper or any other material that could conduct
electrical current. Do not paint drain holes, anodes, the MerCathode system or items
specified by the boat manufacturer.
NOTICE
Washing the MerCathode assembly can damage components and lead to rapid
corrosion. Do not use any cleaning equipment such as brushes or high‑pressure washers
to clean the MerCathode assembly.
To Next Page
Loading...
