Section 6 - Storage
Page 130 90-899883295 JUNE 2008
2. Install a fully charged battery. Clean the battery cable clamps and terminals and
reconnect cables. Tighten each cable clamp securely when connecting.
3. Coat the terminal connections with a battery terminal anti‑corrosion agent.
4. Perform all the checks in the before starting column of the Operation Chart.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will
overheat and suffer damage. Provide a sufficient supply of water to the water inlets during
operation.
5. Start the engine and closely observe instrumentation to ensure that all systems are
functioning correctly.
6. Carefully inspect the engine for fuel, oil, fluid, water and exhaust leaks.
7. Inspect the steering system, shift and throttle control for proper operation.
To Next Page
Loading...
