Mercury Racing 500R - Page 88

3.
Set the lanyard stop switch to the RUN position. Refer to General
Information ‑ Lanyard Stop Switch.
19791
4. Shift the outboard to the neutral (N) position.
a - Forward
b - Neutral
c - Reverse
NOTE:For initial start of a new engine or for an engine that ran out of fuel,
refer to Fuel Supply Module Priming Procedure .
5.
Ignition key starting ‑ Turn the ignition key to the START position and
release the key. The electronic starting system will automatically crank
the engine for starting. If the engine fails to start, the engine will stop
cranking. Turn the key to the START position again until the engine starts.
S
T
A
R
T
O
F
F
A
C C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
3485
a
b
c
51902
OPERATION
 78 eng